SEAL Image 410 Specifications download pdf (Page 18)

- 18 - 3 H

ONE STEP MOUNTING AND LAMINATING

This process allows you to decal and mount in one step

by using a mounting board with heat activated adhesive

on one side

Preparation

n Set the top heaters roll temperature to 110ºC (230°F).

The bottom main roll off.

n Load the heat activated laminate on the top unwind

shaft.

Webbing

n Step one - Set the nip in correspondence with the

heat activated foam board you are using

n Step two - Lay the heat activated laminate across the

face of the top main roller.

n Step three - Use a piece of leader board to hold the

laminate under the top roller. When using this process

a leader board or your product must be in the nip.

This will prevent adhesive from coating the bottom

main roll.

n Step four – Run a sample piece of foam board without

an image. Check for adhesion, wrinkles, and

bubbles. Adjust your heat and brake tension

accordingly.

n Step five – A leader board should be in the nip. Place

an image on your mounting board, and press it

against the leader board. If you are mounting more

than one image, send them through consecutively.

Note: For thick laminates and images, run at a slower

speed. This will allow substrate adhesives to activate

properly.

Heat activated substrate

Film Path

Media

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 28 29

No comments

SEAL Image 410 Specifications Page 18