SEAL PRO 44 Service Manual download pdf (Page 15)

Disassembly / Reassembly Procedures

February 20004-4

4-4. Heating Element

Necessary tools: Allen key 3mm.

Approximate time: 10 minutes.

Note:

To disassemble / reassemble the heating element, it is necessary to perform the ‘Plastic Side

Covers’ Procedure, described in Section 4-3.

Make sure that the power cord is disconnected from the mains!

The heating element (see figure 14), is a quartz

tube, having a spiral wound filament mounted

inside.

The quartz tube is fragile; take care when

handling the element.

To exchange the heating element, perform the

following procedure:

1. Remove, on the left-hand side of the machine, the blue fast-on connector (1) from the

overtemperature switch (2). See figure 15.

2. Slide the heater wire out of the slot that’s in the heater bracket.

3. Cut, at the right hand side of the machine, the two tie-wraps, that hold the wire of the heating

element to the other two (black) wires. See figure 16.

fig. 14

fig. 15

fig. 16

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 41 42

No comments

SEAL PRO 44 Service Manual Page 15