SEAL PRO 44 Service Manual download pdf (Page 19)

Disassembly / Reassembly Procedures

February 20004-8

9. Apply the two new tie-wraps exactly on the original positions (into the holes), put the blue

connector back onto the overtemperature switch, and mount the ground wire back to it’s position.

Put the serrated washers back the way they came off: one on either side of the two wire-eyelets.

4-7. Solid State Relay

Necessary tools: medium flat-head screwdriver, Allen key 3 mm.

Approximate time: 5 minutes.

Note:

To remove the Solid State Relay, it is necessary to perform the ‘Plastic Side Covers’

disassembly procedure (see Section 4-3) first. Only the right hand cover has to be removed.

Make sure that the power cord is disconnected from the mains!

Perform the following steps:

1. Loosen all four screws that

clamp the wires. They are

marked 1 through 4. See figure

24.

2. Bend the wires a bit away from

the Solid State Relay.

3. Remove the two M4 bolts that

hold the Solid State Relay

together with the bent sheet

(fire enclosure), that’s mounted

behind it.

4. Now you can remove the Solid

State Relay, together with the

bent sheet.

5. When mounting the Relay,

make sure that the four

clamping screws and the two

M4 bolts are tight. Don’t forget the serrated washers that belong under the M4 bolt heads.

Note: make sure, that the relay is mounted in the proper way: the coding on the blue wires

should correspond with the numbers on the relay; the two black wires on clamp no. 1, the wire

from the heating element on clamp no. 2.

fig. 24

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 41 42

No comments

SEAL PRO 44 Service Manual Page 19