SEAL Image 410 Troubleshooting Guide download pdf (Page 30)

TROUBLESHOOTING GUIDE

Problem Solution

The laminator will not turn on.

• Check if the power cable is plugged into the mains wall outlet.

• Check the Main Power Stand-by Button. The corresponding LED

should be lit.

• Make sure that the Emergency Stop buttons were not activated. Rotate

to reset.

• Unplug the laminator and check the circuit breakers under the left side

plate. Check the fuse in the power supply. Only authorized safety or

maintenance personnel should do this.

• Make sure the Power Disconnect Switch is in the ON position. Turning

the Power Disconnect Switch to the OFF position automatically shuts

the laminator power off.

The motor will not run.

• Make sure that the photo-eyes are not blocked.

• Check that the Motor ON/OFF Button is pressed ON. The

corresponding LED should be lit.

• Check the motor circuit breaker under the right side plate.

• Unplug the laminator and check the fuse in the motor control. Only

authorized safety or maintenance personnel should do this.

The laminator is not heating up or

shows erratic temperature readings.

• Make sure the Heater Button is pressed ON. The corresponding LED

should be lit.

• Check the circuit breakers on the under side of the left side plate

• Make sure the rollers are together (with both Nip settings set at ‘0’) and

turning at a moderate speed when first heating up.

Images or Prints are rippling or

jumping as they are fed into the nip.

• Apply tension to Images or Prints as they are fed into the nip. Hold cut

sheets back by hand.

The film output is rippled or wavy

(boat-waking)

• Check that you have webbed the laminator correctly.

• Improper film tension – most encapsulating films need a minimal

amount of brake tension.

• Run the laminator at a higher speed for photo materials or heat-sensitive

prints because exposure to heat at low speeds can cause waving.

The film is cloudy or mottled.

• Increase the roller temperature or decrease the motor speed.

• Thicker films may require increased roller pressure due to the thicker

film layer.

Machine shuts down and display

screen is blinking.

• Refer to Error Codes page for definition of problem.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 36

Comments to this Manuals

No comments

SEAL Image 410 Troubleshooting Guide Page 30

Comments to this Manuals

Related products and manuals for Laminators SEAL Image 410