SEAL Image 410 Troubleshooting Guide download pdf (Page 8)

IMPORTANT SAFEGUARDS

SAFETY SYMBOLS USED ON THE

LAMINATOR

IMPORTANT! Read and make sure you

understand these safety and operating

guidelines.

ROTATING PARTS: RISK OF INJURY

CAUTION! Failure to use caution near rotating

rollers could result in physical injury. Be careful

that items such as loose clothing, long hair and

jewelry do not become entangled in rotating parts.

The laminator is equipped with photoelectric eyes to

prevent contact with the rotating rollers. Make sure that

these safety provisions are always in operation/installed.

IMPORTANT! The laminator operation will cease

immediately when the photo electric eyes, set

directly in the path of the front of the rollers, are

blocked. On Domestic version laminators, the foot

switch overrides the photoelectric eyes. When the

photo eye is blocked, a BUZZER sounds, warning

of close proximity to the nip. Use care to keep

hands clear of the rollers while using the foot

switch to prevent possible injury.

HOT SURFACE: RISK OF INJURY ON

CONTACT

CAUTION! The laminator contains heated rollers,

which may reach temperatures of 250°F (121°C).

There is a danger of burns if the heated roller is

touched during use. Even after switching off the

laminator, the roller remains hot for a long time.

ELECTRICAL PARTS – DANGER OF BEING

INJURED BY ELECTRICITY

WARNING! Do not remove the side plate covers

because of the risk of being injured by voltage.

Only authorized maintenance and service

technicians or safety personnel should do this for

mechanical upkeep or repair.

WARNING! Make sure the power disconnect

located on the left side stand leg is turned to the

OFF position before removing the side plate covers

for any maintenance.

IMPORTANT! Do not place heavy objects on the

power supply cord.

PREVENTATIVE MEASURES:

Do not feed objects such as staples, paper clips and

rough or abrasive materials through the laminating

rollers.

Keep all objects, such as tools, rulers, pens, markers or

knives away from the roller opening. Refrain from

leaving such items on the front table to prevent them

from accidentally being fed into the rollers.

IMPORTANT! NEVER cut or slice directly on the

rollers as any cuts or gouges will destroy them.

ALWAYS use cutters with enclosed blades to

prevent cutting the rollers and to avoid extensive

replacement costs.

WARNING! Always adjust the nip setting to create

a gap between the laminating rollers to prevent flat

spots from developing when the laminator is not in

use. Flat spots will affect the quality of the output

and void the warranty replacement.

IMPORTANT! The main roller should be together

and turning while heating up to prevent uneven hot

spots on the roller. A stationary roller will develop

concentrated heat in one area, which will damage

the roller. Pivot the front table away from the

heated roller when not in use to prevent possible

warping and voiding the warranty replacement.

SERVICING AND REPLACEMENT PARTS

Service and maintenance must be performed fully in

accordance with the instructions. Servicing by any

unauthorized technician voids the warranty. The service

technician must use replacement parts specified by

SEAL

Graphics.

Service Technicians must perform safety checks

after completing any service or repairs to the

laminator.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 35 36

Comments to this Manuals

No comments

SEAL Image 410 Troubleshooting Guide Page 8

Comments to this Manuals

Related products and manuals for Laminators SEAL Image 410